產品簡介
回路電阻測量是電氣測試的重要內容,根據《中華人民共和國電力行業標準》DL/T845.4-2004的標準,參照《電阻測量裝置通用技術條件第4部分:回路電阻測試儀》的要求。本公司研制了全新NAHLY回路電阻測試儀,可方便地進行高低壓開關的主觸頭接觸電阻值、高低壓電纜線路的直流電阻值等純阻性試品的測量。
本產品使用了高精度、高穩定度的直流恒流源,可提供固定直流電流輸出,克服了傳統回路電阻測量儀需調節電流輸出的缺點;本產品采用了寬溫帶背光的大屏幕圖形液晶顯示器,而不是傳統的數碼管顯示方式,可直觀的顯示漢字,使得儀器操作顯得更加方便、簡潔;本產品使用了精密儀用運算放大器和高精度A/D轉換器,結合高性能十六位單片機,確保了該產品的測試準確度;本產品還設計了實時日歷時鐘、數據存儲、打印以及保護等功能,使得該產品功能更加完備,性價比更高。
產品別名
回路電阻測試儀、接觸電阻測試儀、開關回路電阻測試儀、接觸回路電阻測試儀、接觸(回路)電阻測試儀
產品特性
1.大電流:采用**電源技術,能長時間連續輸出大電流,克服了脈沖式電源瞬間電流的弊端,可以有效的擊穿開關觸頭氧化膜,得到良好的測試結果。
2.抗干擾能力強:在嚴重干擾條件下,液晶屏**一位數據能穩定在±1個字范圍內,讀數穩定,重復性好。
3.使用壽命長:全部采用高精度電阻,有效的消除環境溫度對測量結果的影響,同時軍品接插件的使用增強了抗振性能。
4.攜帶方便:體積小、重量輕。
產品參數
項?目 | NAHLY-100A | NAHLY-200A | NAHLY-100B | NAHLY-200B | NAHLY-300A | NAHLY-600A | |||||||
測試電流 | 50A,100A | 100A,200A | 50A,100A | 100A,200A | 100A,200A,300A | 100A,200A,300A,600A | |||||||
測量范圍 | 50A | 0~2000μΩ | 100A | 0~2000μΩ | 50A | 0~4000μΩ | 100A | 0~2000μΩ | 100A | 0~50mΩ | 100A | 0~50mΩ | |
100A | 0~2000μΩ | 200A | 0~2000μΩ | 100A | 0~2000μΩ | 200A | 0~2000μΩ | 200A | 0~25mΩ | 200A | 0~25mΩ | ||
? | ? | ? | ? | ? | ? | ? | ? | 300A | 0~15mΩ | 300A | 0~15mΩ | ||
? | ? | ? | ? | ? | ? | ? | ? | ? | ? | 600A | 0~8mΩ | ||
顯示方式 | 3位半數字LCD顯示器 | 中英文液晶顯示屏 | |||||||||||
分?辨?率 | 0.1μΩ | 0.01μΩ | 0.1μΩ | ||||||||||
存儲數據 | 無 | 可以存儲80組測試數據 | - | ||||||||||
計時功能 | 無 | 帶計時功能 | - | ||||||||||
電流顯示 | 不能顯示輸出電流大小 | 可以顯示實際輸出電流值 | - | ||||||||||
打印功能 | 無 | 帶打印功能 | - | ||||||||||
USB接口 | 無 | 帶USB控制端口 | - | ||||||||||
外接PC | 無 | 能將測試數據直接導入到PC電腦進行分析 | - | ||||||||||
測試精度 | ≤0.5% | ||||||||||||
功??率 | - | 3000W | 6000W | ||||||||||
供電電壓 | AC220×(1±10%)V;50×(1±5%)Hz | ||||||||||||
使用溫度 | 0℃?-?45℃(無凝露) | ||||||||||||
相對濕度 | ≤90%RH | ||||||||||||
海拔高度 | 小于1000米 | ||||||||||||
外形尺寸 | 290mm×260mm ×215mm | 360mm×290mm ×245mm | 330mm×280mm ×215mm | 330mm×280mm ×290mm | - | - | |||||||
重?量 | 5.8kg | 9.5kg | 7.7kg | 8.9kg | - | - | |||||||
Product introduction
Used for a variety of high voltage circuit breakers (referred to as switch) main contact contact resistance measurements, you canalsotest thehighvoltage cable lines, busbars, weld and any low resistance non-inductive electrical resistance values, etc.
Accordance with the latest standards "JJG1052-2009 loop resistance test procedures" GB50150-91 and DL/T596-1996 therelevantregulations, can be alongstable output of not less than 100A large current, the instrument can not be avoided continuous work and thus can not effectively breakdown "oxide film" of thestate. Usingthe new power andprecisionmeasurement and control circuits combined, making the measurement data with high accuracy and good reproducibility.
Also called?name
Loop resistance tester, contact resistance tester, switch loop resistance tester, the contact loop resistance tester, touch(loop)resistancetester
The Characteristics of the products
1. large electric current: Using the latest Power technology to a long continuous output high current pulsed power to overcomethedrawbacks oftheinstantaneous current can effectively switch contacts oxide film breakdown, get good test results.
2. anti-interference ability: In severe interference conditions, the LCD screen can be stabilized at last a data ±1digit range, the reading isstableand repeatable.
4. long life: all precision resistors, the effective elimination of ambient temperature on measurement results, while enhancing theuseofmilitaryconnectors vibration resistance.
5. Easy to carry: small size, light weight.
The parameters of the products
ITEM? | NAHLY-100A | NAHLY-200A | NAHLY-100B | NAHLY-200B | ||||
Test current | 50A,100A | 100A,200A | 50A,100A | 100A,200A | ||||
Measure range | 50A | 0~2000μΩ | 100A | 0~2000μΩ | 50A | 0~4000μΩ | 100A | 0~2000μΩ |
100A | 0~2000μΩ | 200A | 0~2000μΩ | 100A | 0~2000μΩ | 200A | 0~2000μΩ | |
Display mode | 3 and half LCD display | LCD Display | ||||||
resolution | 0.1μΩ | 0.01μΩ | ||||||
Store data | no | Can store 80 group test data | ||||||
Time function | no | With timing function | ||||||
Current display | Can't display the size of output current | Can display real output current value | ||||||
Print function | no | With print function | ||||||
USB interface | no | with USB interface | ||||||
External connection PC | no | Can download the tested data to PCforanalysis | ||||||
Precision | ≤0.5% | |||||||
Power supply | AC220×(1±10%)V;50×(1±5%)Hz | |||||||
Operation temp | 0℃ - 45℃(no condensing) | |||||||
Relative humidity | ≤ 90%RH | |||||||
Altitude | ≤ 1000m? | |||||||
Out Dimension | 290×260×215mm | 360×290×245mm | 330×280×215mm | 330×280×290mm | ||||
Weight | 5.8kg | 9.5kg | 7.7kg | 8.9kg | ||||

免責聲明:當前頁為 南澳電氣 NAHLY回路電阻測試儀 進行高低壓開關的主觸頭接觸電阻值測量產品信息展示頁,該頁所展示的 南澳電氣 NAHLY回路電阻測試儀 進行高低壓開關的主觸頭接觸電阻值測量產品信息及價格等相關信息均有企業自行發布與提供, 南澳電氣 NAHLY回路電阻測試儀 進行高低壓開關的主觸頭接觸電阻值測量產品真實性、準確性、合法性由店鋪所有企業完全負責。世界工廠網對此不承擔任何保證責任,亦不涉及用戶間因交易而產生的法律關系及法律糾紛,糾紛由會員自行協商解決。
友情提醒:世界工廠網僅作為用戶尋找交易對象,就貨物和服務的交易進行協商,以及獲取各類與貿易相關的服務信息的渠道。為避免產生購買風險,建議您在購買相關產品前務必確認供應商資質及產品質量。過低的價格、夸張的描述、私人銀行賬戶等都有可能是虛假信息,請您謹慎對待,謹防欺詐,對于任何付款行為請您慎重抉擇。
投訴方式:fawu@gongchang.com是處理侵權投訴的專用郵箱,在您的合法權益受到侵害時,請將您真實身份信息及受到侵權的初步證據發送到該郵箱,我們會在5個工作日內給您答復,感謝您對世界工廠網的關注與支持!